A: Instrument Cluster Connector Pin-Out Tests

^ Measure all voltages to ground with the Ignition Switch in RUN.

^ Measure all resistances to ground with the Ignition Switch off and the negative battery cable disconnected.

^ Check all ground terminals with a self-powered test lamp before making voltage or resistance measurements.

^ If the correct voltage or resistance is not found at the terminal, do the test given or go to the section referred.

^ Cluster Connector as seen from driver's seat with the Instrument Cluster removed.

^ If the correct voltage or resistance is found at the terminal, and the function that uses that terminal does not operate and all appropriate incandescent bulbs have been checked, replace the Instrument Cluster (see Service and Repair).

^ If the correct voltage or resistance is not found at a terminal, do the test given or go to the section referred.