DTC 22

Code 22 Chart:

Wiring Diagram For Throttle Position Sensor:

CIRCUIT DESCRIPTION:

The Throttle Position Sensor (TPS) provides a voltage signal that changes relative to the throttle blade angle. Signal voltage will vary from about 0.33 to 1.33 volts at idle, to about 4.5 volts at Wide Open Throttle (WOT). The TPS signal is one of the most important inputs used by the ECM for fuel control, and for most of the ECM controlled outputs.


TEST DESCRIPTION: The numbers below refer to circled numbers on the diagnostic chart.

1. This checks to see if a Code 22 is the result of a hard code failure or an intermittent problem.
A Code 22 will set under the following conditions:
a. The engine running.
b. TPS signal voltage is less than 0.2 volts (200 mV).
c. The TPS has an auto zeroing feature. If the voltage reading is within the range of about 0.35 to 1.33 volts, the ECM will use that value as closed throttle. If the voltage reading is out of the auto zero range at closed throttle, check for a binding throttle cable or damaged linkage. If OK, continue with diagnosis.

2. Simulates a Code 21, high voltage. If a Code 21 is set, or the "Scan" tool displays over 4.0 volts, the ECM and wiring are OK.

3. Check for a good sensor connection. If the connection is good, replace the TPS.

4. This simulates a high signal voltage to check for an open in circuit 417. The "Scan" tool will not read up to 12.0 volts, but what is important is that the ECM recognizes the signal on circuit 417.


DIAGNOSTIC AIDS:

1. A "Scan" tool displays TPS in volts. Closed throttle voltage should 0.35 to 1.33 volts, and the voltage value should increase at a steady rate as the throttle is opened with the ignition "ON" or engine idling.
2. An open or grounded circuit 416 or 417 will result in a Code 22. If a Code 22 is intermittent, see DIAGNOSIS BY SYMPTOM.