C: Starter Enable Relay Test

C2. Connect a fused jumper between terminals E (YEL) wire and A (TAN/WHT) wire of the Starter Enable Relay Connector. Turn Ignition Switch to START.

^ If engine cranks proceed to C3.

^ If engine does not crank, go to diagnosis of Starter and Charging circuits.

C3. Reconnect the Starter Enable Relay and connect a fused jumper from terminal A3 (BLK/YEL) wire of the PASS Key Decoder Module to ground. Thrn Ignition Switch to START.

^ If engine cranks, replace the PASS Key Decoder Module.

^ If engine does not crank, check the BLK/ YEL (625) wire for an open. If wire is OK, replace the Starter Enable Relay.