Drive, Driven Sprockets and Drive Link Assemble

- Tools Required
- J 29569-1/ J29829-1 Turbine Shaft Seal Installer and Sizer
- J 29569-2/ J 29829-2 Turbine Shaft Seal Installer and Sizer

1. In order to assemble three new Teflon seals onto the turbine shaft, perform the following procedure:
a. Slide both halves of the J29569-1/ J29829-1 over the turbine shaft.
b. Coat the J 29569- 1/ J 29829- 1 with transmission fluid.
c. Use your fingers in order to guide the new Teflon seals over the J 29569-1/ J 29829-1 and into the seal ring grooves on the turbine shaft.
d. Remove the J 29569- 1/ J 29829- 1 when the seals are in place.
e. Size the new Teflon seals. Use both halves of the J 29569-2/ J 29829-2.
f. In order to properly size the seals, keep the J 29569-2/ J 29829-2 in place for five minutes.





2. Assemble the drive sprocket (37) onto the turbine shaft t39)
3. Retain the drive sprocket with the turbine shaft to drive sprocket snap ring (35).