Powertrain Control Module Programming and Setup

1. Ensure the following conditions have been met:
^ The battery is fully charged.
^ The ignition is ON.
^ The cable connection at the Data Link Connector (DLC) is secure.
2. Program the PCM using the latest software matching the vehicle. Refer to Techline terminal/equipment users instructions.
2.1. If the PCM fails to program, proceed as follows:
^ Ensure that all PCM connections are Ok.
^ Check the Techline terminal/equipment for the latest software version.
^ Attempt to program the PCM. If the PCM still cannot be programmed properly, replace the PCM. The replacement PCM must be programmed.
2.2. Program the replacement PCM.
3. Perform the CKP System Variation Learn Procedure if a new PCM is installed. Refer to CKP System Variation Learn Procedure. Programming and Relearning
4. Perform the Idle Learn Procedure. Refer to PCM Idle Learn Procedure. PCM Idle Learn Procedure
5. Perform the Engine Oil Life Reset procedure if a new PCM is installed. Refer to Engine Oil Life Monitor Reset Procedure. Service and Repair

Functional Check
1. Clear the Diagnostic Trouble Codes (DTCs).
2. Perform the On-Board Diagnostic System Check.
3. Start the engine and idle for one minute.
4. Scan for DTCs using the scan tool.