Front Side Door Window Replacement (4 Door)

Front Side Door Window Replacement (4 Door)

Removal Procedure




1. Remove the front side door trim. Refer to Front Side Door Trim Panel Replacement Service and Repair
2. Pull the front door water deflector (2) from the front door in order to gain access to the screws that retain the front door window.




3. Remove the 2 screws (1) that retain the front door window.




4. Remove the front door window from the door.
5. Remove the front door window (1) from the lower sash (6).

Installation Procedure




1. Coat the lower sash (2) with soapy water in order to ease the installation of the front door window (1) into the lower sash (2).
2. Install the front door window (1) to the lower sash (2). Align the window (1) in the lower sash (2). Verify that the distance from the rear screw of the lower sash (2) to the rear edge of the window (1) is 269.5-273.5 mm (10.61-10.76 in).





Notice: Refer to Fastener Notice in Cautions and Notices.

Important: Do not overtighten the front door window screws.


3. Install the front door window to the front door. Secure the window with the 2 screws (1).

Tighten the front door window screws to 5 Nm (44 lb in).




4. Set the screws so that the measurements between the front door window (2) and the front door window channels (1) are equal at the points that are indicated by the 2 sets of arrows.
5. Inspect the window for the correct front-to-rear position and for the correct left-to-right position. Adjust the window if necessary.
6. Apply adhesive to the back of the front door water deflector.
7. Place the water deflector in the normal position.
8. Install the front side door trim. Refer to Front Side Door Trim Panel Replacement Service and Repair