Front Floor Console Trim Plate Replacement

Front Floor Console Trim Plate Replacement

Removal Procedure

1. Apply the park brake.
2. Position the transaxle selector in the low range.
3. Raise the front floor console armrest.
4. Remove the front floor console storage compartment.




5. Remove the mat from the storage compartment.
6. Open the console cup holder.




7. Remove the console trim plate, starting at the rear and pulling up, working forward in order to release the retainers.
8. Remove the console trim plate from the front floor console.




9. Disconnect the electrical connector from the driver's seat heater switch, if equipped.



Installation Procedure





1. Connect the electrical connectors to the driver's seat heater switch, if equipped.




2. Install the trim plate to the front floor console by pressing down firmly until fully seated.
3. Reposition the transaxle selector into PARK.
4. Close the console cup holder.
5. Install the console storage compartment.
6. Lower the console armrest.




7. Install the console storage compartment mat to the console storage compartment.
8. Release the park brake.