P/S Cooler Pipe/Hose Replacement

Removal Procedure
1. Place a drain pan under the vehicle.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
4. Remove the power steering hoses from the power steering cooler pipe.
5. Remove the power steering cooler pipe retaining clip bolt from the frame.





6. Remove the power steering cooler pipe from the retaining clips on the frame.
7. Remove the power steering cooler pipe from the vehicle.

Installation Procedure





1. Install the power steering cooler pipe to the retaining clips on the frame.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the power steering cooler pipe retaining clip bolt to the frame.
3. Tighten the power steering cooler pipe retaining clip bolt to 9.5 Nm (84 inch lbs.).





4. Install the power steering hoses to the power steering cooler pipe.
5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
6. Lower the vehicle.
7. Fill the power steering system. Refer to Refilling the Power Steering System.
8. Bleed the power steering system. Refer to Bleeding Power Steering System.
9. Check the power steering system for leaks. Refer to Power Steering Gear and Pump Leaks.
10. Remove the drain pan from under the vehicle.