B0016

SIR Schematics:

CIRCUIT DESCRIPTION
The inflatable restraint IP module deployment loop consists of the inflatable restraint IP module, the IP module high Circuit, and the IP module low circuit. A shorting bar is used in the inflatable restraint IP module connector to short together the IP module high and IP module low circuits when the connector is disconnected. This will help prevent unwanted deployment of the IP module during servicing. When the ignition is turned ON, the Inflatable Restraint Sensing And Diagnostic Module (SDM) performs continuous diagnostic tests on the deployment loop to check for proper circuit continuity and for shorts to ground or voltage. If a malfunction is detected, the SDM will store a Diagnostic Trouble Code (DTC).

CONDITIONS FOR RUNNING THE DTC
Ignition 1 voltage is within the normal operating voltage range.

CONDITIONS FOR SETTING THE DTC
IP module deployment loop resistance is less than 1.3 ohms for 500 milliseconds.

ACTION TAKEN WHEN THE DTC SETS
The SDM turns the AIR BAG indicator ON.

CONDITIONS FOR CLEARING THE DTC
^ The condition responsible for setting the DTC no longer exists and the scan tool Clear DTCs function is used.
^ A history DTC will clear once 255 malfunction free ignition cycles have occurred.

DIAGNOSTIC AIDS
Thoroughly inspect the wiring and the connectors. An incomplete inspection of the wiring and the connectors may result in misdiagnosis, causing a part replacement with the reappearance of the malfunction.

The following are possible causes of the malfunction:
^ A short between the IP module high and IP module low circuits
^ The IP module connector
^ A malfunctioning IP module
^ The SDM connector
^ An internal SDM malfunction

If an intermittent malfunction exists, refer to Testing for Intermittent and Poor Connections in diagrams.

TEST DESCRIPTION

Steps 1-3:

Steps 4-10:

The number(s) below refer to the step number(s) on the diagnostic table.
4. Tests to see if the malfunction is intermittent
5. Tests to see if the malfunction is caused by the IP module
8. Tests to see if there is a short between the IP module high and IP module low circuits