Ignition Coil: Service and Repair
IGNITION COIL(S) REPLACEMENTREMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Disconnect the spark plug wires.
3. Remove 2 screws (1) securing the coil (2) to the ignition control module (3).
4. Remove the coil (1).
INSTALLATION PROCEDURE
1. Attach the coil assembly (2) to the ignition control module (3).
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the attaching screws (1).
Tighten
Tighten the screws to 4.5 N.m (40 lb in).
3. Connect the spark plug wires.
4. Reconnect the negative battery cable.