Rear Door Window Regulator: Service and Repair
Window Regulator Replacement - Rear Door
Removal Procedure
1. Remove the rear door trim panel. Refer to Trim Panel Replacement - Side Rear Door Service and Repair.
2. Remove the rear door water deflector. Refer to Water Deflector Replacement - Rear Door (Service and Repair) .
3. Remove the rear door inner energy absorber pad. Refer to Energy Absorber Pad Replacement - Inner Rear.
4. Raise the rear door window far enough in order to gain access through the inner door to the window to regulator bolts.
5. Remove the bolts from the rear door window to regulator.
6. Raise the rear door window to the full up position.
7. Tape the rear door window in the full up position.
8. Disconnect the electrical connector (2).
9. Loosen the bolts on the regulator motor. Lift the motor to free the retaining bolts from the slots.
10. Remove the bolts from the rear door window regulator (1,2,3,4).
11. Remove the rear door window regulator from the rear door.
Installation Procedure
1. Install the rear door window regulator (3) and motor (2) to the door.
Notice: Refer to Fastener Notice in Cautions and Notices.
Important: In order to ensure proper orientation of the window regulator to the door, tighten the window regulator bolts in the specified sequence.
2. Install the regulator mounting bolts.
Tighten the rear door window regulator bolts to 10 N.m (89 lb in).
3. Connect the electrical connector.
4. Remove the tape from the rear door window.
5. Lower the rear door window far enough in order to gain access through the inner door panel to the bolts.
6. Install the bolts to the rear door window regulator.
Tighten the window regulator bolts to 10 N.m (89 lb in).
7. Install the rear door inner energy absorber pad. Refer to Energy Absorber Pad Replacement - Inner Rear.
8. Install the rear door water deflector. Refer to Water Deflector Replacement - Rear Door (Service and Repair) .
9. Install the rear door trim panel. Refer to Trim Panel Replacement - Side Rear Door Service and Repair