Removal and Replacement

Driver Information Center Switch Replacement

Removal Procedure





1. Remove the instrument panel cluster trim panel. Refer to Trim Panel Replacement - Instrument Panel (I/P) Cluster (Instrument Panel Cluster (IPC) - Trim Panel Replacement) .
2. Remove the instrument panel center trim panel. Refer toTrim Panel Replacement - Instrument Panel (I/P) Center (Instrument Panel Cluster (IPC) - Trim Panel Replacement) .
3. Remove the HVAC control assembly. Refer to HVAC Control Assembly Replacement in HVAC.
4. From the rear of the switch (3), squeeze the retaining clips (2) on each side of the switch (3) and push the switch (3) part way from the panel (4).
5. Using a plastic flat-bladed tool, hold the retaining clips (2) depressed while slowly removing the switch (3) from the panel (4).
6. Disconnect the wiring connector (1) and remove the switch (3) from the vehicle.



Installation Procedure





1. Connect the wiring connector (1) to the switch (3).
2. Install the switch (3) to the panel (4), making sure the retaining clips (2) are engaged.
3. Install the HVAC control assembly. Refer to HVAC Control Assembly Replacement in HVAC.
4. Install the instrument panel center trim panel. Refer toTrim Panel Replacement - Instrument Panel (I/P) Center (Instrument Panel Cluster (IPC) - Trim Panel Replacement) .
5. Install the instrument panel cluster trim panel (1). Refer to Trim Panel Replacement - Instrument Panel (I/P) Cluster (Instrument Panel Cluster (IPC) - Trim Panel Replacement) .