Inflatable Restraint Steering Wheel Module Replacement

INFLATABLE RESTRAINT STEERING WHEEL MODULE REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the negative battery cable.

CAUTION: Refer to Battery Disconnect Caution.

2. Remove 2 driver air bag module mounting bolts and discard them.

CAUTION: The sensing and the diagnosis module (SDM) can maintain sufficient voltage to deploy the airbags and pretensioners for up to 1 minute after the ignition has been turned OFF and the fuse has been removed. If the airbags and pretensioners are not disconnected, do not begin service until one minute has been passed after disconnecting power to the SDM. Failure to do so may cause personal injury.

3. Remove the connector from the driver air bag module.
4. Remove the driver air bag module.

CAUTION:
- When you are carrying an undeployed inflator module:
- Do not carry the inflator module by the wires or connector on the inflator module
- Make sure the bag opening points away from you
- When you are storing an undeployed inflator module, make sure the bag opening points away from the surface on which the inflator module rests. When you are storing a steering column, do not rest the column with the bag opening facing down and the column vertical. Provide free space for the air bag to expand in case of an accidental deployment. Otherwise, personal injury may result.

INSTALLATION PROCEDURE




1. Install the driver air bag module.
2. Install the connector to the driver air bag module.
3. Install the new driver air bag mounting bolts.

Tighten the driver air bag module mounting bolts to 8 N.m (71 lb in).

NOTE: Refer to Fastener Notice.

4. Connect the negative battery cable.