B3567

DTC B3567

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview)provides an overview of each diagnostic category.



DTC Descriptor
DTC B3567 59
- Driver Information Center Select Switch Circuit/Component Protection Time - Out




Circuit/System Description

The driver information center (DIC) monitors the DIC switch signals to determine the switch inputs. The switch inputs to the DIC is low when a switch is activated. The DIC switch is a momentary contact switch that connects a series of resistors in a resistor ladder format. Each switch state - GAGES, TRIP ODOMETER, SET/RESET, INFO, FUEL, OPTIONS - corresponds to a certain resistance value.


Conditions for Running the DTC

The ignition is in ACCESSORY or RUN.


Conditions for Setting the DTC

The DIC detects that the switch is stuck.


Action Taken When the DTC Sets

The DIC ignores the switch inputs.


Conditions for Clearing the DTC

* The DTC becomes history when the conditions for setting the DTC are no longer present.
* The history DTC clears after 40 malfunction-free warm-up cycles.



Reference Information
Schematic Reference

* Instrument Cluster Schematics (Instrument Cluster Diagrams)
* Driver Information System Schematics (Driver Information System Diagrams)

Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Driver Information Center (DIC) Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning)for Scan Tool Information


Circuit/System Testing

Verify that DTC B3567 is not set.

If DTC B3567 is set , replace the DIC.



Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.


Control Module References (Programming and Relearning)for the DIC replacement, setup and programming