Harmonic Balancer - Crankshaft Pulley: Service and Repair

Crankshaft Balancer Replacement

Special Tools
* J 43653 Flywheel Holding Tool
* J 45059 Angle Meter

Removal Procedure




1. Remove the engine drive belt. Refer to Drive Belt Replacement (With A/C) (Service and Repair)Drive Belt Replacement (Without A/C) (Service and Repair).
2. Remove the starter motor. Refer to Starter Replacement (Service and Repair).
3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
4. Install the J 43653 (1) to the engine block, in order to hold the flywheel.




5. Remove the crankshaft balancer bolt and washer. Discard the bolt.
6. Remove the balancer using a universal removal tool.

Installation Procedure





Caution: Ensure both components are aligned correctly or serious engine damage will occur.

1. Install the crankshaft balancer onto the crankshaft indexing keyway. Use care to properly align the keyway and the flats on the balancer with the oil pump drive.
2. Install the crankshaft balancer using a universal balancer installer.
Caution: Refer to Fastener Caution (Fastener Caution).

Note: Always install a NEW crankshaft balancer bolt and washer.

3. Install a NEW crankshaft balancer bolt and washer. Prevent the crankshaft from rotating when tightening the bolt.

Tighten the bolt to 100 Nm (74 lb ft) plus an additional 125 degrees using the J 45059 .




4. Remove the J 43653 (1) from the engine block.
5. Lower the vehicle.
6. Install the starter motor. Refer to Starter Replacement (Service and Repair).
7. Install the engine drive belt. Refer to Drive Belt Replacement (With A/C) (Service and Repair)Drive Belt Replacement (Without A/C) (Service and Repair).