Inflatable Restraint Side Impact Sensor Replacement

Inflatable Restraint Side Impact Sensor Replacement

Removal Procedure




Warning: Refer to Sensing and Diagnostic Module Voltage after Ignition is Turned Off Warning (Sensing and Diagnostic Module Voltage after Ignition is Turned Off Warning).

Warning: Refer to Battery Disconnect Warning (Battery Disconnect Warning).

1. Disconnect the negative battery cable.
2. Remove the lower trim from the center pillar. Refer to Center Pillar Lower Trim Panel Replacement (Notchback) (Center Pillar Lower Trim Panel Replacement (Notchback))Center Pillar Lower Trim Panel Replacement (Hatchback) (Center Pillar Lower Trim Panel Replacement (Hatchback)).
3. Disconnect the side air bag sensor connector (2).
4. Remove the side air bag sensor mounting bolt.
5. Remove the side air bag sensor (1).

Installation Procedure




1. Install the side air bag sensor (1).

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the side air bag sensor mounting bolt and tighten to 10 Nm (89 lb in).
3. Connect the side air bag sensor connector (2).
4. Install the lower trim to the center pillar. Refer to Center Pillar Lower Trim Panel Replacement (Notchback) (Center Pillar Lower Trim Panel Replacement (Notchback))Center Pillar Lower Trim Panel Replacement (Hatchback) (Center Pillar Lower Trim Panel Replacement (Hatchback)).
5. Connect the negative battery cable.