Transmission Control Replacement
Transmission Control Replacement
Removal Procedure
Note: All shift cable and park lock cable clips are one time usage only. Any service repair requiring cables to be disconnected from the transaxle control cable bracket or shift assembly will require a cable clip replacement.
1. Remove the console. Refer to Console Replacement Console Replacement.
2. Set the park brake.
3. Disconnect the shift cable (2) from the control assembly pin.
4. Remove the shift cable retainer clip and remove the cable (1) from the control assembly.
5. Disconnect the park lock cable assembly (2) from the pin on the control assembly.
6. Depress the tab on the park lock cable and remove the cable (1) from the control assembly. Discard the park lock cable clip.
7. Disconnect the control assembly electrical connectors.
8. Remove the nuts from the control assembly.
9. Remove the control assembly.
Installation Procedure
1. Install the control assembly.
Caution: Refer to Fastener Caution Fastener Caution.
2. Install the control assembly bolts and tighten to 25 Nm (18 lb ft).
3. Release the park brake.
4. Connect the control assembly electrical connectors.
5. Install the park lock cable (1) onto the control assembly using the original clip.
6. Connect the park lock cable (2) onto the control assembly pin.
7. Install the shift cable (1) onto the control assembly. Secure with a new shifter cable retainer clip.
8. Connect the shifter cable (2) onto the control assembly pin.
9. Install the console. Refer to Console Replacement Console Replacement.