Coil Spring Replacement

Coil Spring Replacement (All Wheel Drive and GT)

Special Tools

J-45400 - Strut Spring Compressor

Removal Procedure

1. Remove the spring and shock absorber assembly. Refer to Shock Absorber Replacement (All Wheel Drive and GT) (Rear Suspension Shock Absorber)Shock Absorber Replacement (Except All Wheel Drive and GT) (Rear Suspension Shock Absorber).
2. Use the J-45400 - Compressor , or equivalent, in order to compress the spring.




3. Use a wrench in order to hold the piston rod. Remove the upper nut.




4. Remove the shock absorber upper insulator retainer (9).
5. Remove the shock absorber upper insulator (8).
6. Remove the shock absorber upper mount (7).
7. Remove the shock absorber lower insulator (6).
8. Remove the spring upper insulator (2).
9. Use the J-45400 - Compressor , or equivalent, in order to decompress the spring (3).
10. Remove the spring.
11. Remove the jounce bumper (5).
12. Remove the shock absorber (4).

Installation Procedure

1. Install the jounce bumper to the shock absorber.




2. Install the spring (1) to the shock absorber. Position the lower tip of the spring on the depression in the lower spring seat (2).
3. Use the J-45400 - Compressor , or equivalent, in order to compress the spring.




4. Install the spring upper insulator (2).
5. Install the shock absorber lower insulator (6).





Note: The right rear shock mount is the mirror image of the left rear shock mount.

6. Install the shock absorber upper mount.
Position the front stud 23.3 degrees (a) from the centerline of the lower bolt hole.
7. Install the shock absorber upper insulator.




8. Install the shock absorber upper insulator retainer (1). Ensure the retainer is in the correct position.

Note: Do not tighten the nut. Verify the position of the shock absorber upper mount is correct before tightening the nut.

9. Install the upper nut.
10. Verify the position of the shock absorber upper mount is correct.
11. Remove the spring and shock absorber assembly from the J-45400 - Compressor , or equivalent.





Caution: Refer to Fastener Caution (Fastener Caution).

12. Use a wrench in order to hold the piston rod. Tighten the nut to 39 Nm (29 lb ft).
13. Install the spring and shock absorber assembly. Refer to Shock Absorber Replacement (All Wheel Drive and GT) (Rear Suspension Shock Absorber)Shock Absorber Replacement (Except All Wheel Drive and GT) (Rear Suspension Shock Absorber).