P1813
P1813
Pressure regulator 1 - Open circuit(short circuit to ground, short circuit to B+.
P1818
Pressure regulator 2 - Open circuit/short circuit to ground, short circuit to B+.
P1823
Pressure regulator 3 - Open circuit/short circuit to ground, short circuit to B+.
P1828
Pressure regulator 4 - Open circuit/short circuit to ground, short circuit to B+.
Function:
Pressure regulators (DR) are pressure-control solenoid valves. They transform an electric current into a proportional hydraulic pressure.
Diagnosis Condition:
- Ignition on
Wiring Diagram:
Diagnosis Procedure:
1 Check pressure regulator with wiring.
1. Pull off Tiptronic control module connector.
2. Connect ohmmeter to Tiptronic control module connector:
DR1 = pin 52 and pin 5
DR2 = pin 52 and pin 1
DR3 = pin 52 and pin 29
DR4 = pin 52 and pin 4
Indication: 5 ... 10 ohm.
2 Check wires from Tiptronic control module to transmission connector for continuity.
1. Additionally disconnect connector on transmission.
2. Connect ohmmeter to Tiptronic control module connector and transmission connector:
DR1 = pin 5 and pin 2
DR2 = pin 1 and pin 3
DR3 = pin 29 and pin 7
DR4 = pin 4 and pin 11
Indication: 0 ... 5 ohm.
If infinite ohm is indicated, check wiring harness for crushing and chafing damage.
2 Check wires from Tiptronic control module to transmission connector for short circuit to ground.
1. Connect ohmmeter to Tiptronic control module connector and ground:
DR1 = pin 5 and ground
DR2 = pin 1 and ground
DR3 = pin 29 and ground
DR4 = pin 4 and ground
Indication: infinite ohms.
If 0 ... 5 ohm is displayed,. check wiring harness for crushing and chafing damage.
2 Check wire from Tiptronic control module to transmission connector for short circuit to B+.
1. Switch on ignition.
2. Connect voltmeter to Tiptronic control module connector and ground.
DR1 = pin 5 and ground
DR2 = pin 1 and ground
DR3 = pin 29 and ground
DR4 = pin 4 and ground
Indication: 0 Volt.
If battery voltage is indicated, check wiring harness for crushing and chafing damage.