Removal and Replacement

Throttle Body Assembly Replacement

Removal Procedure




1. Remove the resonator assembly. Refer to Air Cleaner Outlet Resonator Replacement (Air Cleaner Outlet Resonator Replacement).
2. Remove the evaporative emission (EVAP) canister purge line from the throttle body.
3. Disconnect the throttle body electrical connector.
4. Remove the throttle body assembly retaining bolts (1).
5. Remove the throttle body assembly (2) and the gasket from the intake manifold.
6. Clean the gasket surface.

Installation Procedure




1. Install the throttle body assembly (2) to the intake manifold with the gasket.
2. Add sealer GM P/N 12346004 (Canadian P/N 10953480) to the throttle control module bolt threads.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the throttle body assembly retaining bolts (1) and tighten to 10 Nm (89 in. lbs.).
4. Connect the throttle body electrical connector.
5. Install the EVAP canister purge line to the throttle body.
6. Install the resonator assembly. Refer to Air Cleaner Outlet Resonator Replacement (Air Cleaner Outlet Resonator Replacement).