Strut Replacement - Liftgate

Strut Replacement - Liftgate

Removal Procedure

Caution: When a lift gate hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.






1. Open and support the lift gate.

Important: Spring clips should not be removed from struts.


2. Lift up and partially remove the spring clips on the strut using a small flat-bladed tool.
3. Remove the upper end of the strut from the ball joint.
4. Remove the lower end of the strut from the ball joint.
5. Remove the strut from the lift gate.



Installation Procedure





1. Position the strut to the lift gate.
2. Install the upper end of the strut to the ball joint. Press in to place until fully seated.
3. Install the lower end of the strut to the ball joint. Press in to place until fully seated.
4. Remove the support from the lift gate.
5. Close the lift gate.