Catalytic Converter Replacement - Right Side

Catalytic Converter Replacement - Right Side (LZ4) (3.5L)

Removal Procedure

Note: The catalytic converter is serviced by replacing the entire assembly. Always replace the gaskets at the front and rear flanges when servicing the catalytic converter. Never install the original gasket.




1. Remove the heated oxygen sensor (HO2S). Refer to Heated Oxygen Sensor Replacement - Bank 1 Sensor 2 (Service and Repair).
2. Lower the vehicle.
3. Remove the right side exhaust manifold heat shield bolts (1).
4. Remove the right side exhaust manifold heat shield.




5. Remove the right side catalytic converter to exhaust manifold nuts (1).
6. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
7. Support the exhaust system.




8. Remove the catalytic converter to muffler nuts (1).
9. Reposition the muffler assembly rearward until the catalytic converter can be removed.
10. Remove the catalytic converter.
11. Remove the catalytic converter gaskets.
12. Clean and inspect the exhaust manifold and the exhaust pipe gasket mating surfaces.

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the right side catalytic converter to exhaust manifold nuts (1) and tighten to 35 Nm (26 lb ft).




2. Install the right side exhaust manifold heat shield.
3. Install the right side exhaust manifold heat shield bolts (1) and tighten to 10 Nm (89 lb in).




4. Install the exhaust manifold heat shield.
5. Install the right side exhaust manifold heat shield bolts (1) and tighten to 10 Nm (89 lb in).
6. Install the HO2S sensor. Refer to Heated Oxygen Sensor Replacement - Bank 1 Sensor 2 (Service and Repair).