Oil Pan: Service and Repair

Oil Pan Replacement (LAT) (2.4L Hybrid)

Removal Procedure




1. Remove the drive belt. Refer to Drive Belt Replacement (LE5) (Service and Repair)Drive Belt Replacement (LAT) (Service and Repair).
2. Remove the oil level indicator tube. Refer to Oil Level Indicator Tube Replacement (LE5) (Service and Repair)Oil Level Indicator Tube Replacement (LAT) (Service and Repair).

Note: The support fixture bar must be installed to provide enough access to remove and properly tighten the oil pan bolts.

3. Install the engine support fixture. Refer to Engine Support Fixture (Engine Support Fixture).
4. Remove engine mount to bracket bolts (2).
5. Remove the engine mount to side rail nuts (1).
6. Remove the engine mount from the engine compartment.
7. Using the engine support fixture, raise the engine approximately 3 inches.
8. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).




9. Loosen the upper air conditioning (A/C) compressor bolts.
10. Remove the lower A/C compressor bolt.




11. Place a suitable drain pan under the oil pan drain plug.
12. Remove the oil pan drain plug.
13. Drain the engine oil.
14. Reinstall the oil pan drain plug until snug.




15. Disconnect the engine wiring harness electrical connector (1) from the generator control module coolant pump.




16. Remove the generator control module coolant pump bolt.
17. Remove the generator control module coolant pump from the oil pan.




18. Remove the 4 oil pan to transaxle bolts.
19. Remove the oil pan bolts.




20. Remove the oil pan
21. Remove any old oil pan sealant (1).

Installation Procedure




1. Ensure that the oil pan and the sealing surface on the lower crankcase are free of all oil and debris.
2. Apply a 2 mm bead of sealant (1) around the perimeter of the oil pan and the oil suction port opening. DO NOT over apply the sealant. More than a 2 mm bead is not required. Refer to Adhesives, Fluids, Lubricants, and Sealers (Specifications).
3. Install the oil pan.




4. Install the oil pan bolts.

Caution: Refer to Fastener Caution (Fastener Caution).

5. Install the 4 oil pan to transaxle bolts and tighten to 75 Nm (55 lb ft).




6. Tighten the oil pan bolts in the sequence shown to 25 Nm (18 lb ft).




7. Install the generator control module coolant pump to the oil pan. Ensure that the anti-rotation tab is inserted into the hole in the oil pan.
8. Install the generator control module coolant pump bolt and tighten to 25 Nm (18 lb ft).




9. Connect the engine wiring harness electrical connector (1) to the generator control module coolant pump.
10. Lower the vehicle.




11. Using the engine support fixture, lower the engine.
12. Place the engine mount onto the side rail studs.
13. Install the engine mount to side rail nuts (1) and tighten to 100 Nm (74 lb ft).
14. Install engine mount to bracket bolts (2).
15. Tighten the engine mount to bracket bolts in the following sequence.

1. Middle
2. Rear
3. Front
Tighten the bolts to 50 Nm (37 lb ft).

16. Remove the engine support fixture.
17. Install the oil level indicator tube. Refer to Oil Level Indicator Tube Replacement (LE5) (Service and Repair)Oil Level Indicator Tube Replacement (LAT) (Service and Repair).
18. Install the drive belt. Refer to Drive Belt Replacement (LE5) (Service and Repair)Drive Belt Replacement (LAT) (Service and Repair).
19. Fill the engine oil to the proper level.