P0A1F

DTC P0A1F, P1A01, P1A05, or P1A06

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.

DTC Descriptors
DTC P0A1F
- Battery Energy Control Module Internal Performance

DTC P1A01
- Battery Energy Control Module Long Term Memory Performance

DTC P1A05
- Battery Energy Control Module Random Access Memory (RAM)

DTC P1A06
- Battery Energy Control Module Read Only Memory (ROM)

Circuit/System Description

The drive motor generator battery control module will diagnose its own systems and determine when a fault condition is present. Diagnostics and system status is communicated from the drive motor generator battery control module to the drive motor generator control module through serial data. The drive motor generator control module is the host controller for diagnostic trouble code (DTC) information.

This diagnostic applies to internal microprocessor integrity conditions within the drive motor generator battery control module. This is an internal electronic fault detection diagnostic of the drive motor generator battery control module. This fault is internal to the drive motor generator battery control module and no external circuits are involved. Failure of these diagnostics can cause erratic hybrid drive motor battery and HV contactor operation.

The drive motor generator battery control module performs tests on its own internal memory to detect failures. No external circuits are involved. Failure of these diagnostics can cause erratic hybrid drive motor battery and HV contactor operation.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

The drive motor generator battery control module has detected an internal malfunction.

Action Taken When the DTC Sets

* DTCs P0A1F, P1A01, P1A05, and P1A06 are type A DTCs.
* The contactors will either open or will not change state, depending on conditions.
* The malfunction indicator lamp (MIL) turns ON.

Conditions for Clearing the DTC

DTC P1A01 will pass if the EEPROM checksum matches when the ignition is turned OFF.

Reference Information
Schematic Reference

Hybrid Energy Storage Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Drive Motor Generator Battery Description (Drive Motor Generator Battery Identification Information)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (Diagnostic Trouble Code Descriptions)
Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information
Special Tools

EL-48900 HEV Safety Kit

Circuit/System Verification

If the DTC is set, replace the drive motor generator battery control module.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the repair.

Control Module References (Programming and Relearning) for drive motor generator battery control module replacement, setup and programming