Control Valve Body Replacement

Control Valve Body Replacement

Removal Procedure





1. Remove the control valve body cover.
2. Slide the grey locking clip in order to unlock the connector for the input and output speed sensor assembly.
3. Press the connector tab and remove the connector for the input and output speed sensor assembly from the control valve body assembly.





4. Remove the bolt and manual shaft detent assembly from the control valve body assembly.





5. Disconnect the manual valve link assembly from the manual valve.





6. Remove the 3 silver bolts from the control valve body assembly.





Important: Use care when removing the control valve body assembly. The control solenoid valve assembly and the control valve body assembly may separate.

7. Remove the 15 black bolts from the control valve body assembly.





8. Remove the control valve body assembly from the transmission case assembly.
9. Remove the spacer plate assembly. Discard the spacer plate assembly.

Installation Procedure





1. Install a NEW spacer plate assembly on the transmission case assembly.
2. Install the control valve body assembly on the transmission case assembly.





Notice: Refer to Fastener Notice in Service Precautions.

3. Secure the control valve body assembly to the transmission case assembly with the 3 silver bolts.
^ Tighten the 3 silver bolts to 8 Nm (6 ft. lbs.) in the sequence shown.





4. Secure the control valve body assembly to the transmission case assembly with the 15 black bolts.
^ Tighten the 15 black bolts in three separate steps in the sequence shown.
4.1. Tighten to 5 Nm (4 ft. lbs.)
4.2. Tighten to 10 Nm (7 ft. lbs.)
4.3. Tighten to 15 Nm (11 ft. lbs.)





Important: Note the orientation of the manual valve before connecting the manual valve link assembly.

5. Connect the manual valve link assembly to the manual valve.





6. Install the manual shaft detent assembly and bolt on the control valve body assembly.
^ Tighten the bolt to 11 Nm (8 ft. lbs.).





7. Connect the connector for the input and output speed sensor assembly to the control valve body assembly.
8. Slide the grey locking clip in order to lock the connector in place.
9. Install the control valve body cover.