P0300
DTC P0300SYSTEM DESCRIPTION
The engine control module (ECM) uses information from the crankshaft position (CKP) sensor and the camshaft position (CMP) sensor in order to determine when an engine misfire is occurring. By monitoring variations in the crankshaft rotation speed for each cylinder, the ECM is able to detect individual misfire events. A misfire rate that is high enough can cause 3-way catalytic converter damage. The malfunction indicator lamp (MIL) will flash ON and OFF when the conditions for catalytic converter damage are preset. DTCs P0301-P0306 correspond to cylinders 1-6. If the ECM is able to determine that a specific cylinder is misfiring, DTC P0300 will set.
CONDITIONS FOR RUNNING THE DTC
- DTCs P0121, P0122, P0123, P0222, P0223, P0335, P0341, P0342, P0343, P0440, P0443, P0444, or P0445 are not set.
- The engine speed is between 520-6,520 RPM.
- The torque management is not active.
- The antilock brake (ABS) system is not active.
- The ECM is not receiving a rough road signal.
- The ECM is not in fuel shut-off or decel mode.
- The engine has been running for longer than 5 seconds.
- The intake air temperature (IAT) is more than -30°C (-22°F).
CONDITIONS FOR SETTING THE DTC
The ECM is detecting a crankshaft rotation speed variation indicating a misfire rate sufficient to cause emissions levels to exceed mandated standards.
ACTION TAKEN WHEN THE DTC SETS
- The control module illuminates the malfunction indicator lamp (MIL) on the second consecutive ignition cycle that the diagnostic runs and fails.
- The control module records the operating conditions at the time the diagnostic fails. The first time the diagnostic fails, the control module stores this information in the Failure Records. If the diagnostic reports a failure on the second consecutive ignition cycle, the control module records the operating conditions at the time of the failure. The control module writes the operating conditions to the Freeze Frame and updates the Failure Records.
CONDITIONS FOR CLEARING THE MIL/DTC
- The ECM turns OFF the MIL after 3 consecutive drive trips that the diagnostic runs and does not fail within the same conditions that the DTC last failed.
- A History DTC clears after 40 consecutive warm-up cycles if no failures report by this diagnostic or any other emission related diagnostic.
- The DTC can be cleared with a scan tool
DIAGNOSTIC AIDS
Excessive vibration from sources other than the engine could cause DTC P0300 to set. The following are possible sources of vibration:
- Thickness variation of the brake rotors.
- Worn or damaged accessory drive belt.
TEST
