C0280

DTC C0280

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview)provides an overview of each diagnostic category.



DTC Descriptor
DTC C0280 00
- Stability System Active Too Long




Circuit/System Description

The yaw rate and lateral accelerometer sensor monitors the motion of the vehicle for the EBCM to maintain control and stabilize the vehicle during most driving conditions.


Conditions for Running the DTC

Engine Running


Conditions for Setting the DTC

The yaw rate and lateral accelerometer sensor indicates the vehicle motion needs the vehicle stability enhancement system (VSES) activated, and the EBCM detects either the brakes are not applied for at least 15 seconds, or the brakes are applied for at least 45 seconds during this VSES event.


Action Taken When the DTC Sets

One or more of the following actions may occur:

* The EBCM disables VSES.
* The driver information center (DIC) illuminates the warning indicator/message.



Conditions for Clearing the DTC

* The condition for the DTC is no longer present.
* The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.



Reference Information
Schematic Reference

Antilock Brake System Schematics ([1][2]Antilock Brakes / Traction Control Systems)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

ABS Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning)for scan tool information


Circuit/System Verification

1. Verify that the DTC sets outside of the Conditions for Running and Setting. Since most occurrences of this DTC are caused by excessive driving maneuvers, review with the customer the conditions under which the DTC set.

• If the DTC set within the Conditions for Running and Setting, the VSES is operating as designed.

2. Operate the vehicle within the conditions that the customer experienced and verify the DTC does not reset.

• If the DTC resets, replace the yaw rate sensor and lateral accelerometer.




Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.


Vehicle Yaw Sensor with Vehicle Lateral and Longitudinal Accelerometer Replacement (Service and Repair)