C0550

DTC C0550

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.



DTC Descriptor
DTC C0550
- Electronic Control Unit (ECU) Performance




Circuit/System Description

The electronic brake control module (EBCM) detects an internal malfunction.


Conditions for Running the DTC

The ignition is ON.


Conditions for Setting the DTC

An internal EBCM malfunction exists.


Action Taken When the DTC Sets

One or more of the following actions may occur:

* The antilock brake system (ABS) dynamic rear proportion (DRP) are disabled.
* ETS is degraded.
* The ABS/ESC/ETS indicators illuminates.
* The red BRAKE Warning indicator illuminates.



Conditions for Clearing the DTC

The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.


Reference Information
Schematic Reference

Antilock Brake System Schematics ([1][2]Antilock Brakes / Traction Control Systems)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

ABS Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning) for Scan Tool Information


Circuit/System Verification

Verify that DTC C0550 is not set.

If the DTC is set, clear the DTC with a scan tool, and operate the vehicle within the conditions for setting the DTC. If the DTC reset, replace the EBCM.



Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.


Control Module References (Programming and Relearning) for EBCM replacement, setup, and programming