Brake Pedal Position Sensor Replacement

Brake Pedal Position Sensor Replacement

Removal Procedure

1. Remove the instrument panel insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (Service and Repair).
2. Remove the intermediate steering shaft bolt and position the intermediate steering shaft away from the steering column in order to gain access to the brake pedal adjustment position sensor. Refer to Intermediate Steering Shaft Replacement (Intermediate Steering Shaft Replacement).
3. Disconnect the electrical connector from the brake pedal position sensor.




4. Remove the bolt from the position sensor, and remove the position sensor from the vehicle.



Installation Procedure






Notice: Refer to Fastener Notice (Fastener Notice).


Important: Do not reuse the position sensor bolt. Always use a new bolt when installing a brake pedal position sensor.


1. Install the brake pedal position sensor and the bolt to the brake pedal bracket.

Tighten the bolt to 2 N.m (18 lb in).

2. Connect the electrical connector to the position sensor.
3. Install the intermediate steering shaft to the steering column. Refer to Intermediate Steering Shaft Replacement (Intermediate Steering Shaft Replacement).
4. Install the instrument panel insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (Service and Repair).
5. Calibrate the position sensor. Refer to Brake Pedal Position Sensor Calibration (Programming and Relearning).