Removal and Replacement

Throttle Body Assembly Replacement

Removal Procedure





1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement (Air Cleaner Outlet Duct Replacement).
2. Disconnect the engine wiring harness electrical connector (2) from the electronic throttle control (ETC).




3. Remove the throttle body bolts.
4. Remove the throttle body and gasket. Discard the gasket.



Installation Procedure





1. Position a NEW throttle body gasket to the upper intake manifold.
2. Position the throttle body to the upper intake manifold.

Notice: Refer to Fastener Notice (Fastener Notice).

3. Install the throttle body bolts.

Tighten the bolts to 10 N.m (89 lb in).





4. Connect the engine wiring harness electrical connector (2) to the ETC.
5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement (Air Cleaner Outlet Duct Replacement).
6. Perform the Throttle Learn Procedure. Refer to Throttle Learn (Programming and Relearning).