Variable Induction Control Solenoid: Service and Repair

Intake Manifold Tuning Valve Actuator Solenoid Replacement

Removal Procedure

1. Raise the hood.
Warning: Refer to Battery Disconnect Warning (Service Precautions).

2. Disconnect the battery.
Loosen the nut.
3. Raise the vehicle by its full height.





Note: Unlatch the lock.

4. Remove the intake manifold tuning valve actuator solenoid (2).

* Detach the 2 vacuum hoses (3).
* Disconnect the wiring harness plug (1).
* Unclip from the intake manifold.

Installation Procedure

1. Install the intake manifold tuning valve actuator solenoid.

* Clip onto the intake manifold.
* Attach the 2 vacuum hoses.
* Connect the wiring harness plug.

2. Lower the vehicle by its full height.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Connect the battery.

Tighten the nut to 5 Nm (44 lb in).

4. For programming procedures, refer to Control Module References (Programming and Relearning).
5. Lower the hood.