Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Intake

CAMSHAFT POSITION ACTUATOR SOLENOID VALVE SOLENOID REPLACEMENT - BANK 1 (RIGHT SIDE) INTAKE

Removal Procedure






1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement (Service and Repair).

2. Remove the air conditioning (A/C) line push pin retainer and reposition the line out of the way.

3. Loosen the bank 1 intake camshaft position (CMP) actuator solenoid valve bolt enough to disconnect the engine wiring harness electrical connector from the CMP actuator solenoid valve.

4. Disconnect the engine wiring harness electrical connector (7) from the CMP actuator solenoid valve.






5. Remove the CMP actuator solenoid valve bolt.

6. Remove the CMP actuator solenoid valve.

7. Inspect the CMP actuator solenoid valve seal and replace as necessary.

Installation Procedure






1. Inspect the CMP actuator solenoid valve seal for damage. Replace the seal if necessary.

2. Install the CMP actuator solenoid valve.

3. Loosely install the CMP actuator solenoid valve bolt.






4. Connect the engine wiring harness electrical connector (7) to the bank 1 intake CMP actuator solenoid valve.

Caution: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Do not use paints, lubricants, or corrosion inhibitors on fasteners, or fastener joint surfaces, unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems. When using fasteners that are threaded directly into plastic, use extreme care not to strip the mating plastic part(s). Use hand tools only, and do not use any kind of impact or power tools. Fastener should be hand tightened, fully seated, and not stripped.

5. Tighten the CMP actuator solenoid valve bolt to 10 Nm (89 lb in).

6. Position the A/C line and install the push pin retainer.

7. Install the air cleaner assembly. Service and Repair