P0335

AC: DTC P0335 - CRANKSHAFT POSITION SENSOR CIRCUIT MALFUNCTION

DTC DETECTING CONDITION:
- Immediately at fault recognition.

TROUBLE SYMPTOM:
- Engine stalls.
- Failure of engine to start

CAUTION: After repair or replacement of faulty parts, conduct CLEAR MEMORY MODE and INSPECTION MODE. Refer to How To Clear Diagnostic Trouble Codes. Clearing Diagnostic Trouble Codes





WIRING DIAGRAM

10AC1: CHECK HARNESS BETWEEN CRANKSHAFT POSITION SENSOR AND ECM CONNECTOR.
1. Turn ignition switch to OFF.
2. Disconnect connector from crankshaft position sensor.

Connector & Terminal (E10) No.1 - Engine ground:

3. Measure resistance of harness between crankshaft position sensor connector and engine ground.

CHECK: Is the resistance more than 100 Kohm?

YES: Repair harness and connector.

NOTE:
In this case, repair the following:
- Open circuit in harness between crankshaft position sensor and ECM connector.
- Poor contact in ECM connector.
- Poor contact in coupling connector (B22).

NO: Go to step 10AC2.

10AC2: CHECK HARNESS BETWEEN CRANKSHAFT POSITION SENSOR AND ECM CONNECTOR.

Connector & Terminal (E10) No.1 - Engine ground:

Measure resistance of harness between crankshaft position sensor connector and engine ground.

CHECK: Is the resistance less than 10 ohms?


YES: Repair ground short circuit in harness between crankshaft position sensor and ECM connector.

NOTE: The harness between both connectors are shielded. Repair ground short circuit in harness together with shield.

NO: Go to step 10AC3.

10AC3: CHECK HARNESS BETWEEN CRANKSHAFT POSITION SENSOR AND ECM CONNECTOR.

Connector & Terminal (E10) No. 2 - Engine ground:

Measure resistance of harness between crank-shaft position sensor connector and engine ground.

CHECK: Is the resistance less than 5 ohm?

YES: Go to step 10AC4.

NO: Repair harness and connector.

NOTE:
In this case, repair the following:
- Open circuit in harness between crankshaft position sensor and ECM connector.
- Poor contact in ECM connector.
- Poor contact in coupling connector (B22).

10AB4: CHECK CONDITION OF CRANKSHAFT POSITION SENSOR.

CHECK: Is the crankshaft position sensor installation bolt tightened securely?

YES: Go to step 10AC5.

NO: Tighten crankshaft position sensor installation bolt securely.

10AC5: CHECK CRANKSHAFT POSITION SENSOR.
1. Remove crankshaft position sensor.

Terminals No.1 - No.2:

2. Measure resistance between connector terminals of crankshaft position sensor.

CHECK: Is the resistance between 1 and 4 Kohm?

YES: Repair poor contact in crankshaft position sensor connector.

NO: Replace crankshaft position sensor.