P0340

AE: DTC P0340 - CAMSHAFT POSITION SENSOR CIRCUIT MALFUNCTION

DTC DETECTING CONDITION:
- Immediately at fault recognition

TROUBLE SYMPTOM:
- Engine stalls.
- Failure of engine to start.

CAUTION: After repair or replacement of faulty parts, conduct CLEAR MEMORY MODE and INSPECTION MODE. Refer to How To Clear Diagnostic Trouble Codes. Clearing Diagnostic Trouble Codes





WIRING DIAGRAM

10AE1: CHECK HARNESS BETWEEN CAMSHAFT POSITION SENSOR AND ECM CONNECTOR.
1. Turn ignition switch to OFF.
2. Disconnect connector from camshaft position sensor.

Connector & Terminal (E15) No.1 - Engine ground:

3. Measure resistance of harness between camshaft position sensor connector and engine ground.

CHECK: Is the resistance more than 100 Kohm?

YES: Repair harness and connector.

NOTE:
In this case, repair the following:
- Open circuit in harness between camshaft position sensor and ECM connector.
- Poor contact in ECM connector.
- Poor contact in coupling connector (B22).

NO: Go to step 10AE2.

10AE2: CHECK HARNESS BETWEEN CAMSHAFT POSITION SENSOR AND ECM CONNECTOR.

Connector & Terminal (E15) No.1 - Engine ground:

Measure resistance of harness between camshaft position sensor connector and engine ground.

CHECK: Is the resistance less than 10 ohm?

YES: Repair ground short circuit in harness between camshaft position sensor and ECM connector.

NOTE: The harness between both connectors are shielded. Repair ground short circuit in harness together with shield.

NO: Go to step 10AE3.

10AE3: CHECK HARNESS BETWEEN CAMSHAFT POSITION SENSOR AND ECM CONNECTOR.

Connector & Terminal (E15) No.2 - Engine ground:

Measure resistance of harness between camshaft position sensor connector and engine ground.

CHECK: Is the resistance less than 5 ohms?

YES: Go to step 10AE4.

NO: Repair harness and connector.

NOTE:
In this case, repair the following:
- Open circuit in harness between camshaft position sensor and ECM connector.
- Poor contact in ECM connector.
- Poor contact in coupling connector (B22).

10AE4: CHECK CONDITION OF CAMSHAFT POSITION SENSOR.

CHECK: Is the camshaft position sensor installation bolt tightened securely?

YES: Go to step 10AE5.

NO: Tighten camshaft position sensor installation bolt securely.

10AE5: CHECK CAMSHAFT POSITION SENSOR.
1. Remove camshaft position sensor.

Terminals No.1 - No.2:

2. Measure resistance between connector terminals of camshaft position sensor.

CHECK: Is the resistance between 1 and 4 Kohm?

YES: Repair poor contact in camshaft position sensor connector.

NO: Replace camshaft position sensor.