With Manufacturer's Scan Tool

Clear Memory Mode

OPERATION

1. SUBARU SELECT MONITOR (NORMAL MODE)
1. On the "Main Menu" display screen, select {Each System Check}.
2. On the "System Selection Menu" display screen, select {Engine Control System}.
3. Select the [OK] after the information of engine type has been displayed.
4. On the "Engine Diagnosis" display screen, select the {Clear Memory}.
5. When the Done and Turn Ignition Switch OFF are shown on the display screen, turn the ignition switch to OFF, and then Subaru Select Monitor to OFF.

NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.

2. SUBARU SELECT MONITOR (OBD MODE)
1. On the "Main Menu" display screen, select {Each System Check}.
2. On the "System Selection Menu" display screen, select {Engine Control System}.
3. Select the [OK] after the information of engine type has been displayed.
4. On the "Engine Diagnosis" display screen, select {OBD System}.
5. On the "OBD Menu" display screen, select {DTC Clear}.
6. When the Clear Diagnostic Code? is shown on the screen, select the [OK].
7. Turn the ignition switch to OFF and then close the Subaru Select Monitor.

NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.