Subaru Select Monitor
Subaru Select MonitorOPERATION
1. READ DIAGNOSTIC TROUBLE CODE (DTC)
When malfunction of the airbag system occurs, the DTC stored in airbag control module will be read out.
1. Prepare the Subaru Select Monitor kit.
2. Connect the diagnosis cable to the Subaru Select Monitor.
3. Connect the Subaru Select Monitor to the data link connector.
1. The data link connector is located in the lower portion of the instrument panel (on the driver's side).
2. Connect the diagnosis cable to the data link connector.
CAUTION: Do not connect the scan tools other than the Subaru Select Monitor.
4. Turn the ignition switch to ON (engine OFF) and run the Subaru Select Monitor.
5. On the [[Main Menu]] display screen, select {Each System Check}.
6. On the [[System Selection Menu]] display screen, select the {Airbag System}.
7. Select the [OK] after the {ABS} is displayed.
8. On the [[Airbag System]] screen, select the {DTC Display}.
NOTE:
- For details concerning the operation procedure, refer to the �help on PC application for Subaru Select Monitor�.
- For details concerning DTCs, refer to List of Diagnostic Trouble Code (DTC).
2. DISPLAY OF STATUS INFORMATION
Check the operating condition of each sensor in the event of malfunction in the seat belt buckle switch and seat position sensor, or when the seat belt buckle switch and seat position sensor has been replaced.
1. On the [[Main Menu]] display screen, select {Each System Check}.
2. On the [[System Selection Menu]] display screen, select the {Airbag System}.
3. On the [[Airbag System]] display screen, select the {Status Data}.
The given table is for support data.
NOTE: For details concerning the operation procedure, refer to the [[PC application for Subaru Select Monitor]].
3. CLEAR MEMORY MODE
Clear the DTC stored in the airbag control module after repairing the airbag system. (After the breakdown is recovered, the breakdown code for completed recoveries are read out when the next breakdown occurs if the memory clear work is not performed.)
1 On the [[Main Menu]] display screen, select {Each System Check}.
2 On the [[System Selection Menu]] display screen, select the {Airbag System}.
3 On the {Airbag System} menu screen, select the {Clear Memory}.
4 When the Clear Memory? is shown on the screen, select the [OK].
5 When Done is displayed, close the Subaru Select Monitor.
NOTE: For details concerning the operation procedure, refer to the [[PC application for Subaru Select Monitor]].
INSPECTION
1. COMMUNICATION FOR INITIALIZING IMPOSSIBLE
DETECTING CONDITION:
Defective harness connector
TROUBLE SYMPTOM:
Communication is impossible between the airbag control module and the Subaru Select Monitor.
WIRING DIAGRAM:
Wiring Diagram:
Step 1-7:
Step 8-11:
2. WITHOUT DTC
DETECTING CONDITION:
- Defective combination meter
- Open circuit of harness
TROUBLE SYMPTOM:
- Airbag warning light remains on.
- "NO TROUBLE CODE" will be displayed on the Subaru Select Monitor.
For detailed operation procedures, refer to "Airbag Warning Light Failure".
NOTE: When the airbag warning light is OFF and NO TROUBLE CODE is displayed on Subaru Select Monitor, the system is operating properly.