Read Diagnostic Trouble Code (DTC)
Subaru Select MonitorOPERATION
READ DIAGNOSTIC TROUBLE CODE (DTC)
1) Prepare the Subaru Select Monitor kit.
2) Prepare PC with Subaru Select Monitor installed.
3) Connect the USB cable to SDI (Subaru Diagnosis Interface) and USB port on the personal computer (dedicated port for the Subaru Select Monitor).
NOTE:
The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
4) Connect the diagnosis cable to SDI.
5) Connect SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).
CAUTION:
Do not connect the scan tools other than the Subaru Select Monitor.
6) Start the PC.
7) Turn the ignition switch to ON.
8) Run the "PC application for Subaru Select Monitor".
9) On [Main Menu] display, select (Each System Check).
10) On [System Selection Menu] display, select (Transmission Control System).
11) After transmission type information pops up, select [OK].
12) On [Transmission Diagnosis] display, select (Diagnostic Code(s) Display).
13) On [Diagnostic Code(s) Display] display, select (Temporary Diagnostic Code(s)) or (Memorized Diagnostic Code(s))
NOTE:
^ For details concerning the operation procedure, refer to "PC application help for Subaru Select Monitor".
^ For details concerning DTC, refer to "List of Diagnostic Trouble Code (DTC)". List of Diagnostic Trouble Codes (A/T)