Read Diagnostic Trouble Code (DTC)

Read Diagnostic Trouble Code (DTC)

OPERATION

1) On [[Main Menu]] display, select {Each System Check}.
2) On [[System Selection Menu]] display, select {Brake Control System}.
3) Click the [OK] button after the {VDC} is displayed.
4) On [[Brake Control Diagnosis]] display, select {Diagnostic Code(s) Display}.
5) Record the DTC and data.

NOTE:
^ For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".
^ For details concerning DTCs, refer to "List of Diagnostic Trouble Code (DTC)". Diagnostic Trouble Code Descriptions
^ Up to 3 DTCs are displayed in the order of detection.
^ If a particular DTC is not stored in memory properly at the occurrence of problem (due to a drop in VDCCM&H/U power supply etc.), the DTC suffixed with a question mark "?" is displayed on Subaru Select Monitor display screen. This shows it may be an unreliable reading.





Inspection Mode

PROCEDURE

Reproduce the malfunction occurrence condition as much as possible.

Drive the vehicle at least ten minutes.

NOTE:
Make sure the vehicle is not dragged to one side under usual driving condition.