Read Diagnostic Trouble Code (DTC)

Read Diagnostic Trouble Code (DTC)

OPERATION

1) On [[Main Menu]] display, select {Each System Check}.
2) On [[System Selection Menu]] display, select {Brake Control System}.
3) Click the [OK] button after {VDC} is displayed.
4) On [[Brake Control Diagnosis]] display, select {Diagnostic Code(s) Display}.
5) Record the DTC and data.

NOTE:
^ For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".
^ For details concerning DTCs, Diagnostic Trouble Code Descriptions
^ Up to 3 DTCs are displayed in the order of detection.
^ If a particular DTC is not stored in memory properly at the occurrence of problem (due to a drop in VDCCM&H/U power supply etc.), the DTC suffixed with a question mark "?" is displayed on Subaru Selects Monitor display screen. This shows it may be an unreliable reading.





Inspection Mode

PROCEDURE

Reproduce the malfunction occurrence condition as much as possible.
Drive the vehicle at least ten minutes.

NOTE:
Make sure the vehicle is not dragged to one side under usual driving condition.

Clear Memory Mode

OPERATION

1) On [[Main Menu]] display, select {Each System Check}.
2) On [[System Selection Menu]] display, select {Brake Control System}.
3) Click the [OK] button after {VDC} is displayed.
4) On [[Brake Control Diagnosis]] display, select {Clearing Memory}.
5) When the "Clear Memory?" is shown on the screen, click the [YES] button.
6) When "Done" and "Turn off the ignition switch." are shown on the display screen, turn the ignition switch to OFF.

NOTE:
For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".