Electric Parking Brake Switch: Service and Repair
Parking Brake SwitchREMOVAL
1) Disconnect the ground cable from battery.
2) Remove the instrument panel lower cover.
(1) Remove the clips, and remove the instrument panel side cover LH.
(2) Remove the clips and data link connector, and remove the instrument panel lower cover under.
(3) Remove the screws and clips and release the claws, and remove the instrument panel lower cover while disconnecting the harness connectors.
3) Remove the screws and remove the parking brake switch.
INSTALLATION
Install each part in the reverse order of removal.
INSPECTION
PARKING BRAKE CONTROL SWITCH
Check the resistance between parking brake control switch terminals.
NOTE:
Replace the switch if the inspection result is not within the standard value.
HILL HOLD SWITCH
Check the resistance between hill hold switch terminals.
NOTE:
Replace the switch if the inspection result is not within the standard value.