Read Diagnostic Trouble Code (DTC)

READ DIAGNOSTIC TROUBLE CODE (DTC)

1) Prepare the Subaru Select Monitor kit.
2) Prepare PC with Subaru Select Monitor installed.
3) Connect the USB cable to the SDI (Subaru Diagnostic Interface) and the USB port of the personal computer (port for Subaru Select Monitor).

NOTE:
The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.

4) Connect the diagnosis cable to SDI.
5) Connect the SDI to the data link connector located in the lower portion of the instrument panel (on the driver's side).

CAUTION:
Do not connect scan tools other than the Subaru Select Monitor.

6) Start the PC.
7) Turn the ignition switch to ON (engine OFF).
8) Run the "PC application for Subaru Select Monitor".
9) On the <

> display screen, select the {Each System Check}.
10) On the <>, select {Transmission Control System}.
11) After transmission type information pops up, select [OK].
12) On the <> display screen, select {Diagnostic Code(s) Display}.
13) On the <> screen, select the {Temporary Diagnostic Code(s)} or {Memorized Diagnostic Code(s)}