Clearing Diagnostic Trouble Codes

CLEAR MEMORY MODE

1) Shift the select lever to "P" range.
2) On the [[Main Menu]] display screen, select the {Each System Check}.
3) On the [[System Selection Menu]], select {Transmission Control System}.
4) After transmission type information pops up, select [OK].
5) On the [[Transmission Diagnosis]] display screen, select {Clear Memory}.
6) When "Done. Turn ignition switch to OFF" pops up, select [OK].
7) Turn the Subaru Select Monitor and ignition switch to OFF. To turn the ignition switch to ON again, wait for more than 10 seconds.

NOTE:
^ To clear the previous DTC, use {Clear Memory}, and to clear the learned value, use {Clear Memories 2}.
^ For details concerning the operation procedure, refer to the "PC application help for Subaru Select Monitor".