P0500

WIRING DIAGRAM

CIRCUIT DESCRIPTION
Refer to "Electrical Diagrams".




DTC DETECTING CONDITION AND TROUBLE AREA

DTC CONFIRMATION PROCEDURE

NOTE: Check to make sure that following conditions are satisfied when using this DTC CONFIRMATION PROCEDURE.

WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and very careful during to avoid occurrence of an accident.
- Road test, should be carried out with 2 person, a driver and tester, on a level road.

- Intake air temperature: between -14°C and 70°C (6.8°F and 158°F)
- Atmospheric pressure: higher than 560 mm.Hg (Altitude: lower than 2790 m (9150 ft))

1. With ignition switch OFF, connect scan tool.
2. Turn ON ignition switch and clear DTC by using scan tool if any.
3. Start engine and warm up to normal operating temperature.
4. Increase vehicle speed till engine speed is reached 4000 rpm. in 3rd gear (M/T) or 2nd range (A/T).
5. Release accelerator pedal and with engine brake applied, keep vehicle coasting and then stop vehicle.
6. Check DTC by using scan tool.

Steps 1 - 5:

Steps 6 - 7:

DTC TROUBLESHOOTING