P0111

Wiring Diagram:

Detecting Condition/Trouble Area:

DTC CONFIRMATION PROCEDURE

WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.

1. Connect scan tool to DLC with ignition switch OFF.
2. Turn ON ignition switch and clear DTC, pending DTC and freeze frame data in ECM memory by using scan tool and start engine.
3. Check vehicle and environmental condition for:
- Engine coolant temp. at engine start: 30 °C (14 °F and 86 °F) or lower.
4. Warm up engine to normal operating temperature and confirm that intake air temp. is 60 °C, 140 °F or higher and engine coolant temp. is within 75 - 110 °C, 167 - 230 °F.
5. Drive vehicle above 35 mph (55 kph) for 3 min. or more.
6. Stop vehicle with engine running at idle for 3 min. or more.
7. Check pending DTC and DTC.

Troubleshooting ( Steps 1 - 3 ):