E - Air Bag Warning Lamp CAN't Indicate Flashing Pattern of DTC

Table E - "Air Bag" Warning Lamp Cannot Indicate Flashing Pattern Of DTC




Wiring Diagram

CAUTION:
- Be sure to perform "Air Bag Diagnostic System Check" before starting diagnosis according to flow the table.

Special Tool (A): 09932-75020

- When measurement of resistance or voltage is required in this table, use a tester along with a correct terminal adapter from special tool (Connector test adapter kit).
- When a check for proper connection is required, refer to "Intermittent And Poor Connections".
- If there is wire open in the air bag wire harness or the wire harness, connector or terminal is found damaged, replace the wire harness, connector and terminal as an assembly.

TABLE E (Steps 1 - 3):

NOTE: Upon completion of inspection and repair work, perform following items.
1. Reconnect all air bag system components, ensure all components are properly mounted.
2. Repeat "Air Bag Diagnostic System Check Flow Table", referring to confirm that the trouble has been corrected.