P0771

DTC P0771 (No.67) Shift Solenoid-E Performance or Stuck OFF





DTC Detecting Condition and Trouble Area





Table for detecting condition

DTC Confirmation Procedure

WARNING:
^ When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
^ Road test should be carried out with 2 persons, a driver and tester, on a level road.

1. Connect scan tool to DLC with ignition switch OFF.
2. Clear DTCs in TCM and ECM memories by using scan tool.
3. Start engine and warm it up to normal operating temperature.
4. Shift select lever to "N" and "D" range for each 10 seconds.
5. Start vehicle and increase vehicle speed to 65 km/h (40 mile/h) with throttle position 10% or more.
6. Stop vehicle.
7. Start vehicle and increase vehicle speed to 65 km/h (40 mile/h) with throttle position 10% or more.
8. Stop vehicle and turn ignition switch OFF.
9. Repeat Steps 3) to 7) one time.
10. Stop vehicle.
11. Check DTC, pending DTC and freeze-frame data.

DTC Troubleshooting

Steps 1 & 2:

Are they in good condition?