P2A00
DTC P2A00 : O2 Sensor (Bank 1 Sensor-1) Circuit Slow Response / PerformanceWiring Diagram:
Wiring Diagram
DTC Detecting Condition and Trouble Area
DTC Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.
NOTE: Check to make sure that the following conditions are satisfied when using this "DTC Confirmation Procedure".
- Intake air temp.: -8 degrees C (18 degrees F) or higher
- Engine coolant temp.: 74 - 110 degrees C (165 - 230 degrees F)
- Altitude (barometric pressure): 2400 m, 8000 ft or less (560 mmHg (75 kPa) or more)
1. Connect scan tool to DLC with ignition switch turned OFF.
2. Turn ON ignition switch and clear DTC, pending DTC and freeze frame data by using scan tool and start engine.
3. Increase vehicle speed to 55 km/h (35 mph) or more.
4. Keep driving above vehicle speed for 2 min. or more (Change of vehicle speed is permitted in this step).
5. Stop vehicle, and run engine at idle speed for 1 min.
6. Check if pending DTC exists by using scan tool. If not, check if oxygen sensor monitoring test has completed by using scan tool. If not in both of above checks (i.e., no pending DTC and oxygen sensor monitoring test not completed), check vehicle condition (environmental) and repeat Steps 3) through 6).
Step 1 - 3:
Step 4 - 6:
DTC Troubleshooting