P0128
P0128 Thermostat FunctionOn Board Diagnosis Logic
NOTE: If DTC P0128 is displayed with DTC P0300, P0301, P0302, P0303, P0304, P0305 or P0306, first perform the trouble diagnosis for DTC P0300, P0301, P0302, P0303, P0304, P0305, P0306. Refer to [P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308 Misfire]. P0300
Engine coolant temperature has not risen enough to open the thermostat even though the engine has run long enough.
This is due to a leak in the seal or the thermostat being stuck open.
P0128:
Diagnosis Procedure
Step 1-2:
Component Inspection
ENGINE COOLANT TEMPERATURE SENSOR
1. Check resistance between engine coolant temperature sensor terminals 1 and 2 as shown in the figure.
[Reference data]
2. If NG, replace engine coolant temperature sensor.
DTC Confirmation Procedure
NOTE: If DTC Confirmation Procedure has been previously conducted, always perform the following
before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
WITH SDT
TESTING CONDITION:
- For best results, perform at ambient temperature of -10 °C (14 °F) or higher.
- For best results, perform at engine coolant temperature of -10 °C (14 °F) to 56 °C (133 °F).
- Before performing the following procedure, do not add fuel.
1. Turn A/C switch OFF.
2. Turn blower fan switch OFF.
3. Turn ignition switch ON.
4. Select "COOLAN TEMP/S" in "Data list" mode with SDT.
5. Check the indication of "COOLAN TEMP/S".
If it is below 56 °C (133 °F), go to following step.
If it is above 56 °C (133 °F), cool down the engine to less than 56 °C (133 °F). Then go to next steps.
6. Start engine and wait at idle for at least 10 minutes under the following conditions.
VHCL SPEED SE More than 56 km/h (35 MPH)
CAUTION: Always drive vehicle at a safe speed.
NOTE: If "COOLAN TEMP/S" increases to more than 71 °C (160 °F) within 30 minutes, turn ignition switch OFF because the test result will be OK.
7. Check 1st trip DTC.
8. If 1st trip DTC is detected, go to [P0128 Thermostat Function].
WITH GST
Follow the procedure "WITH SDT" above.