P1814

P1814 Wait Detection Switch

Description
The wait detection switch detects if the transfer case is in 4WD. DTC P1814 will set if an improper signal from the wait detection switch is input due to open or short circuit.

DTC Logic

DTC DETECTION LOGIC





DTC CONFIRMATION PROCEDURE

Step 1:

Diagnosis Procedure

Step 1:

Steps 1-2:

Steps 2-3:

Steps 4-5:

Step 6:

Component Inspection
1) Turn ignition switch "OFF". (Stay for at least 5 seconds.)
2) Disconnect wait detection switch harness connector.
3) Remove wait detection switch.
4) Push and release wait detection switch and check continuity between wait detection switch terminals 10 and 11.








5) If the inspection results are abnormal replace the wait detection switch.