P0117
P0117, P0118 ECT Sensor
Component Description
The engine coolant temperature sensor is used to detect the engine coolant temperature. The sensor modifies a voltage signal from the ECM. The modified signal returns to the ECM as the engine coolant temperature input. The sensor uses a thermistor which is sensitive to the change in temperature. The electrical resistance of the thermistor decreases as temperature increases.
[Reference data]
*: This data is reference value and is measured between ECM terminal 73 (Engine coolant temperature sensor) and ground.
CAUTION:
Never use ECM ground terminals when measuring input/output voltage. Doing so may result in damage to the ECM's transistor. Use a ground other than ECM terminals, such as the ground.
On Board Diagnosis Logic
These self-diagnoses have the one trip detection logic.
Fail-Safe Mode
When this malfunction is detected, the ECM enters fail-safe mode and the MIL lights up.
DTC Confirmation Procedure
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
with SDT
1 Turn ignition switch ON and wait at least 5 seconds.
2 Check DTC.
3 If DTC is detected, go to "Diagnosis Procedure".
with GST
Follow the procedure "WITH SDT" above.
Diagnosis Procedure
1. CHECK GROUND CONNECTIONS
1 Turn ignition switch OFF.
2 Loosen and retighten two ground screws on the body. Refer to [Power Supply and Ground Circuit Check] Power Supply and Ground Circuit Check.
OK or NG
OK
GO TO 2.
NG
Repair or replace ground connections.
2. CHECK ECT SENSOR POWER SUPPLY CIRCUIT
1 Disconnect engine coolant temperature (ECT) sensor harness connector.
2 Turn ignition switch ON.
3 Check voltage between ECT sensor terminal 1 and ground with SDT or tester.
OK or NG
OK
GO TO 3.
NG
Repair open circuit, short to ground or short to power in harness or connectors.
3. CHECK ECT SENSOR GROUND CIRCUIT FOR OPEN AND SHORT
1 Turn ignition switch OFF.
2 Disconnect ECM harness connector.
3 Check harness continuity between ECT sensor terminal 2 and ECM terminal 67.
Refer to Wiring Diagram.
4 Also check harness for short to ground and short to power.
OK or NG
OK
GO TO 4.
NG
Repair open circuit, short to ground or short to power in harness or connectors.
4. CHECK ENGINE COOLANT TEMPERATURE SENSOR
Refer to "Component Inspection".
OK or NG
OK
GO TO 5.
NG
Replace engine coolant temperature sensor. Refer to [Thermostat and Thermostat Housing: Exploded View] Thermostat and Thermostat Housing: Exploded View.
5. CHECK INTERMITTENT INCIDENT
Refer to [Service Information for Electrical Incident: Intermittent Incident] Service Information for Electrical Incident: Intermittent Incident.
INSPECTION END
Component Inspection
Engine Coolant Temperature Sensor
1) Check resistance between engine coolant temperature sensor terminals 1 and 2 as shown in the figure.
[Reference data]
2) If NG, replace engine coolant temperature sensor.